Provo Craft Cuttlebug 6″x7″ Spacer Block

The Provo Craft Cuttlebug 6"x7" Spacer Block (often referred to as "Spacer Plate A") is a mandatory foundational accessory for the manual Cuttlebug die-cutting and embossing machine. It is required to build the correct sandwich thickness for cutting and embossing papercrafts.

Purpose and Function

• The "A" Plate: The 6"x7" block is the thick, durable white base plate that dictates the base height of your Cuttlebug die/embossing sandwich.
• Not a Cutting Surface: It acts as a spacer layer and should never be used as a mat directly in contact with a cutting blade, as this will ruin it.
• Versatility: It allows the machine to work optimally not just with Cuttlebug dies, but with a variety of other popular die and embossing folder brands.

How to Use the Sandwich

To get crisp edges and deep embossing, your plates need to be stacked in a specific order depending on your project type: [1]

• For Embossing Folders:
  1. Spacer Block (A)
  2. Embossing Folder with paper inside
  3. B Plate (the clear cutting mat)
• For Cutting Dies:
  1. Spacer Block (A)
  2. B Plate
  3. Cutting Die (cutting edge facing up)
  4. Cardstock / Paper
  5. Second B Plate

Maintenance and Tips

• Flip for Longevity: Because the spacer plate is subjected to heavy pressure, you can flip it over and use the reverse side once the front starts bowing or wearing out.
• Use Shims for Thinner Dies: If you are using thinner dies from other brands, you may need to place a piece of cardstock on top as a "shim" to increase the height and ensure a clean cut.